HawthorneVillager.com

Hawthorne Village (Milton) Discussion Board
It is currently Sat May 02, 2026 8:37 pm

All times are UTC - 5 hours




Post new topic Reply to topic  [ 23 posts ]  Go to page Previous  1, 2
Author Message
 Post subject:
PostPosted: Wed Jun 22, 2011 8:03 am 
Offline

Joined: Tue Mar 22, 2005 11:54 am
Posts: 4211
Location: Phase 13, Barr Crescent, Thistle Bay A
That is what sucks about these energy star homes. All the moisture is trapped between the soil outside your foundation and the Vapour Barrier in your basement. YES it is normal in a new home, but YES there could be a foundation leak as well that can get fixed underwarranty if you can see it behind the insulation.

Keep an eye out for muddy sediment (hard to with basement dust) and explore from there.

Matt


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 9:03 am 
Offline

Joined: Sat Apr 03, 2010 9:58 pm
Posts: 4286
CupcakeMommies wrote:
So, you don't think it's a problem with any cracks or leaks in the plumbing?

Glad to hear that... we'll see what they have to say this afternoon


Nope - you'll be fine... just run a dehumidifier for a couple of years...


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 9:50 am 
Offline
User avatar

Joined: Wed Sep 05, 2007 3:49 pm
Posts: 1248
Location: No man's land between Milton & Sauga....
Halton Home Inspector wrote:
I agree that this is normal in a new home at this time of year.

To remove the moisture, it would help if you had a dehumidifier with a hose to drain into the floor drain or the sump pit.

To help remove the moisture from behind the vapour barrier I would also suggest that you cut large upside down V's into the plastic barrier and pull plastic down to expose the insulation.

This will enable the moisture to migrate out from behind the barrier.

The V is intentional because in the fall the cut plastic will be easy to repair with some red Tuck Tape.

When / if you get your AC running, that will also help remove moisture from the home.


Glad to see its not something the OP has to worry about.


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 9:53 am 
Offline
User avatar

Joined: Tue Aug 31, 2010 10:34 am
Posts: 2123
Location: Milton
Me too! I am soooo relieved. Now I don't have to go into the PDI this afternoon with my claws out! haha!


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 10:14 am 
Offline
User avatar

Joined: Sun Jun 01, 2008 10:14 am
Posts: 4834
Location: Milton
CupcakeMommies wrote:
Me too! I am soooo relieved. Now I don't have to go into the PDI this afternoon with my claws out! haha!


Hang on a minute, don't put those claws away yet.

If you have hardwood in the house, take a straight edge, like the edge of a ruler with you. Get on the floor and put the straight edge across the boards to see if they are laying flat. If the edges are high then your hardwood floor is "cupped" and this issue must specifically be noted on the PDI form.

Don't let the PDI Rep squirm their way out of noting this "cupping" specifically or you will regret it.

Why,,, because this "cupping" issue must be identified during the PDI in order to get the floor replaced.

Tarion Article Number: 12.21

Condition: STRIP HARDWOOD FLOORING IS CUPPED (HIGH EDGES)
Acceptable Performance/Condition: Strip hardwood flooring shall be installed without cupping.

Warranty: One-Year – Work and Materials • Damage caused by improper maintenance is excluded from the statutory warranty. • Cupping caused by excessive humidity due to failure by the homeowner to maintain adequate ventilation is excluded from the statutory warranty.
Action: One complete heating and cooling season should be allowed as the problem may remedy itself. Cupping identified at the time of the PDI shall be repaired. Cupping that occurs after the PDI and is proven to result from defective work or materials shall be repaired.
Remarks: Identify any damaged hardwood flooring on the PDI Form to avoid any dispute about whether the damage was caused by the builder. Cupping of hardwood strip flooring results from excessive moisture when the humidity below the finished flooring material is substantially higher than above. The homeowner has a responsibility to maintain indoor humidity levels through humidification, ventilation, air conditioning or dehumidification to prevent permanent, irreversible damage. A hygrometer can be used to monitor indoor humidity levels. The immediate sanding of a cupped floor without first allowing it to correct itself may cause even more damage. This condition commonly occurs when houses do not have adequate ventilation and can, under certain circumstances, result from defects in work or materials. See Appendix A2 “Moisture and Wood Floors” for more information.

_________________
For Home Inspection services call Andy Shaw at Halton Home Inspection Service. 905 876 4761


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 10:14 am 
Offline

Joined: Mon Mar 30, 2009 1:32 pm
Posts: 222
Location: Spirit Phase 5B
we had the exact same thing last year when we moved in to our new home. I freaked out and called mattamy. they expalined it was the condensation and for us to run a dehumidifier. we did and once we got the ac going it got better. After the summer was over it was gone. this year we havent had any (knock on wood)

_________________
J & J
Image


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 11:37 am 
Offline
User avatar

Joined: Tue Aug 04, 2009 2:44 pm
Posts: 126
We also went through this when we moved into our new house last year and a dehumidifier did the trick for us.

_________________
Image


Top
 Profile  
Reply with quote  
 Post subject:
PostPosted: Wed Jun 22, 2011 11:46 am 
Offline

Joined: Wed Jul 30, 2008 8:23 pm
Posts: 1107
AlphaMale wrote:
Google Megan Fox's thumb, that's what I mean.


yes, when Googling Megan Fox, I am sure a majorty of the men do not add the word "thumb" as their choice body part. But each to their own.


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 23 posts ]  Go to page Previous  1, 2

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group
[ Time : 0.021s | 10 Queries | GZIP : Off ]