| HawthorneVillager.com http://www.hawthornevillager.com/phpbb/ |
|
| Help with Craftsman Garage Door Opener http://www.hawthornevillager.com/phpbb/viewtopic.php?f=1&t=21773 |
Page 1 of 1 |
| Author: | OddJobJay [ Tue Oct 27, 2009 1:20 pm ] |
| Post subject: | |
Pull the red cord to disconnect the GDO then see if the door will move freely. Is it belt drive, or chain? |
|
| Author: | BuildingHomes.ca [ Tue Oct 27, 2009 9:27 pm ] |
| Post subject: | |
If the sensors cannot see each other, then the door will not close and the light bulbs will flash. The door will still open. If you pull the release handle and move the door manually. Does it move up and down freely? Press the remote button and see if the trolley moves on the rail. If it does not move, then there either the belt is no longer attached to the gear on the opener, or something inside the opener is broken. |
|
| Author: | Linda [ Wed Oct 28, 2009 5:53 pm ] |
| Post subject: | |
The help line for Craftsman is 1-800-528-5236. I had a problem with my garage door opener and they were very helpful. |
|
| Author: | gdm894 [ Sat Oct 31, 2009 7:30 am ] |
| Post subject: | |
If you decide to take it apart; be careful with the belt. You don't want to suddenly release tension on it and have it snap back at you causing an injury. Check the manual, call the help line or get professional help for proper disassembly! |
|
| Author: | BuildingHomes.ca [ Sat Oct 31, 2009 10:55 am ] |
| Post subject: | |
I'll be in Milton tomorrow doing another 6 openers.. Perhaps I can stop in quickly between them and give it a look. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |
|