King Luis wrote:
prickly_pete wrote:
LovelyThanks4Asking wrote:
Tractor Supply sells heated hoses that don't freeze up... hot tub stores do also, but they're a few hundred dollars cuz they're for hot tubs lol
Just disconnect the hose and bring it inside or in the garage. No biggie.
could also fill up a bucket from inside and spread it nicely over the entire area creating a nice sheet. don't just dump it in one spot as it would just create a high spot.
LOL!!! Thanks, that was awesome....
Another awesome trick to getting picture perfect ice is to line up your family from the kitchen sink to the back yard. Then start passing coffee cups of hot water from one person to the next, you know...Like an old western fire drill.
Clearly advice from somebody who has never, ever made a rink...
So here is some advise from somebody who does make a rink every year.
Mine is 80' x 110' and there is only one way to do it so we can use it all year.
Southern Ontario has some unique challenges with the weather which makes it a challenge.
Put the boards down and then make a bowl with a liner.
If you don't put water in it right away say good buy to it and try again next year as the first bit of wind that gets under it will misplace it by a Km or 2 in minutes.
So once the bowl is built. Put 3 or 4 inches of water in it. It will take all day. Stop once all the high spots are covered by at least 1" - 2 would be better.
Sit back and wait for it to freeze. Go out daily to pick out any crap that gets into it. Don't underestimate the importance of this. A simple brown leaf 2" under the ice will ruin at least 2 square feet of ice once the sun hits it and can take weeks to get it back if you ever manage to.
Once it freezes, probably mid December or so, then go out and start applying layers of water to it.
best time of day is late afternoon when the sun is not quite down but still warming up the surface enough to slow the freezing so you get a nice smooth finish.
Some hints. Take the time to paint your boards white. Unfinished wood not only deteriorates in a hurry and kills the boards for next year, but the boards that face the sun will absorb the heat and melt a couple of inches of ice on sunny days. Get close to it with a skate and you slice right through the liner.
I always use boards to back the liner and the then another layer of boards on the inside as well so the liner is sandwiched between the boards. if you don't do this skates, sticks, and pucks will damage that line in a matter of hours and the first melt we get, the season is over.
like Pete said - Buy a rink tarp. it is white and reflective. You get to skate much sooner in the year and the season will last much longer as well. During those feb melts we get here in southern ont. the rink will hold up way better and you will be back on it in no time.
NOT like Pete said - Don't use a sprinkler unless it is above zero outside. Otherwise the drops "Pebble" the surface and as you skate it all starts to chip up. Best is a hose with no nozzle, just water it and build it up slowly.
When it snows, get it off right away. If you leave it a few days the snow insulates the ice and starts to form crystals. Again, it could take weeks to get the ice back if you let that happen. If it gets bad enough, when you water it you end up with a sandwich of air/crystals and the ice on top is always cracking and chipping up.
have fun,
It is a lot of work but if your family skates, it is also a blast providing mother nature cooperates